AVAILABLE OPTIONS

Swath Spreader*
Use this option when extra aeration is required. The spreader provides a thinner and wider swath. Raking may be necessary to put the material back into a swath form.*2 models available.

Windrow Inverter
The mold board moves the windrow to one side after processing. It can be used to merge windrows up to 14’ cut. This allows the baler to pick up two windrows at the same time. The mold board can be adjusted to move the windrow up to 6’ to one side, depending on the setting.

Windrower
Use this option to put the windrow back in the same spot it was picked up from. It will lay a smooth evenly distributed windrow, without bunching or skipping. The adjustable side shields of the windrower allows the operator to set the windrow to the desired width.

Tedder
Because the density of the swath is an important factor in the drying rate, the spreading of the crop as wide as possible via the tedder results in faster drying due to increased absorption of solar radiation.